Moscow mills successfully implements its second Okuma Mu400VA.This Machine enhances Moscow Mills already significant capability with short run high value add prismatic components.
Full textMoscow Mills has successfully installed its new Wenzel Coordinate measurement machine (CMM).The addition of this equipment and a full time inspector has significantly augmented our ability to create the best parts and assemblies possible for our customers.
Full textMoscow Mills purchases a new 5 axis Wenzel XTREME LH 8.10.7 CMM with open DMIS software.This ultra accurate CMM has a volumetric measuring cube of 31.5" Yx39.4 " 27.6". This new equipment is scheduled for installation during the end June 2008
Moscow Mills purchases another Okuma MU400VA 5 axis machining center and will break ground on phase 1 of a planned 8000 Square foot building expansion in May,2008
Moscow Mills is pleased to announce the addition of our new Okuma MU400 5 axis machining center. The addition of this simultaneous 5 axis capable machine will enhance our already significant capabilities by allowing ultra accurate access to 5 sides of a component in one setup.
Moscow Mills welcomed Congressman Peter Welch to our facility on April 4th.
Full textMoscow Mills announced today that it has changed over to biodegradable Soy based lubricants and coolants on all its equipment.